This my 3D printed version of the pool party graves gun from league of legends. A friend asked me to make it for his cosplay. After two months of drawing it over from internet pictures for references. I printed it in 6 weeks but assembly took me because of sanding and school another 3 months. After drawing the big gun in one piece I drew over the drawing to cut out every single piece and added ways to put the gun back together. From the tip of the barrel to the beginning of the shoulder stock is almost everything screwed together except the outer parts who are reinforced with plastic rods glued on the inside. The water tanks are clear pvc pipes painted blue from the inside.
The guns weights around 5 to 6 kilo`s and it is 1.2 meters long and 30 cm wide. This thing was a big journey with loads of accidents and lessons learned through the hard way. A couple of these lessons are:
0 Reacties
zijn er ezelsbruggetjes om de namen van schroefraad en de formules van schroefdraad te onthouden?
is er een andere manier omdat makkelijker te leren?
|